The distribution frame is the most important component in the floor management room system, and it is the hub that realizes the cross-connection of the two subsystems, the vertical trunk line and the horizontal wiring. Patch panels are usually installed on cabinets or walls. Category 5 distribution frame mainly refers to the distribution frame that specifically meets the gigabit transmission performanceCategory 5 distribution frames are mainly used for gigabit networks. Manufacturers advocate them. Now they are also commonly used in local area networks because they are not much more expensive than Category 5 cables. The current Category 6 distribution frames are generally used for ATMs. In the network, the company LAN is not recommended for the time being. At present, the common type of super five or six patch panels in general LANs, especially the current super five and six patch panels can easily provide 155Mbps communication bandwidth, and has the potential to upgrade to gigabit bandwidth, so , Has become the first choice for today's horizontal wiring. The patch panel can be divided into: shielded patch panel and unshielded patch panel. Most local area networks use unshielded patch panel (UTP—Unshielded Twisted Pair) as the transmission medium of wiring for networking.

RJ45 PlugThe method of connecting the crystal head has been posted many times in previous articles. Generally, it is crimped according to the line sequence of T568B: orange white-orange-green and white-blue-blue and white-green-brown and white-brown, arrange the lines The order of the cores, after cutting flat, insert the cores side by side into the crystal head according to the upward direction of the crystal head chip, and then put it into the 8P port of the network cable pliers, and press it.Tools: Use ordinary network cable pliers for Category 5 and Category 6, and special network cable pliers for Category 7 cables. No need to use the network cable pliers without crystal plug.2. ModuleThere are two ways to connect to the module, T568A and T568B. Generally, the T568B wire sequence is used for crimping. After the grooves are matched, use a wire cutter to punch the wire.When connecting the module, it is necessary to ensure a unified standard, which is the same as the crystal head, and there are numbers from 1 to 8 in the logo, which must be sorted in numerical order and then crimped.Tools: wire punching knife, no punching type module does not need to use wire punching knife.3. Distribution frameThe distribution frame also has two wiring methods, T568A and T568B, and the wiring method is also very simple. Take the six types of network cables as an example:Use a wire stripper to remove the outer cover and cross frame of the network cable;Then insert the core of the network cable into the card slot of the corresponding wire sequence;Then buckle the cable management ring into the slot and fix it with a cable tie to prevent it from falling off;Finally, install the distribution frame on the cabinet with cabinet screws.PS: The connection method of the patch panel is similar to that of the module, but the label of the wire sequence will be different for patch panels of different brands, so please pay attention to it when connecting.

This toolless keystone jack comes with concise and compact design. The toolless means not having punching tool for termination,fast and easy installation. It supports both T568A/B wiring . The color label on the cap is visible for guiding. The jack meets Cat6A standard , also compatible with lower classes like CAT6.5E●Toolless without having punching tool for termination●Dual-color-coded Labeling for 568A/B (258A) Wiring Schemes●It compatible with standard wall plate, blank patch panel